do not press the back button…
Enter your VAT number here and click Verify:
Your details have been verified. VAT number registered to:
,
.
Your order will now be zero rated for VAT purposes. We reserve the right to verify these details after your order request has been made and reinstate VAT if required.
Your VAT details were not recognised or were invalid. Your VAT number must be matched to your Billing Country as specified above. This is currently specified as . You do not need to enter the country code part of your VAT number as this has already been selected in your billing address details above.
The VAT number checking service is currently offline. Please supply your VAT details within the comments or special instructions field below and we will apply a VAT discount after placing your order request.
- Porsche 914 (1970-1976)
Vertical Targa Roof Seal Set
This replacement set renews the upright seals located between the rear edges of the door windows and the roll bar.
Fits
- Porsche 914 (1970–1976)
Diagram ref no 36
What This Product Does
Each vertical seal fits into the aluminium retaining channel on the roll bar and closes the joint behind the door glass. The formed sealing lip helps restrict water, draughts and wind noise from entering the cabin when the windows and removable roof are correctly aligned.
Functions
- Seals the rear vertical edge of each door window
- Fits within the roll-bar aluminium channels
- Helps limit water ingress around the side glass
- Reduces air gaps and wind whistle
- Supports correct sealing of the Targa roof system
Technical Details
- Complete left- and right-hand vertical seal set
- Left-hand OE reference: 91453114310
- Right-hand OE reference: 91453114410
- Location: rear edge of the door glass on the roll bar
- One complete set is required per vehicle
- Exploded-parts diagram reference: 36
Symptoms of Fault
- Water entering near the rear corners of the side windows
- Wind whistle or increased cabin noise at speed
- Cracked, hardened, flattened or torn rubber
- Visible gaps between the glass and roll-bar seal
- Damp trim, carpets or musty cabin odours
- Squeaks or rattles around the Targa roof and door glass
Why Replacement Matters
Age, sunlight, temperature changes and repeated compression can cause the original rubber to shrink or lose flexibility. Renewing both vertical seals can restore a continuous contact surface around the door glass, helping to protect the cabin and surrounding trim from moisture. Window position, roof alignment, latches and drainage paths should also be inspected, as these work together with the seals to provide effective weather protection.
FAQs
- Where are these seals installed?
They slide into the upright aluminium channels on the roll bar, directly behind the door windows. - Does the set cover both sides?
Yes. It contains the corresponding left- and right-hand vertical seals. - Why might a Porsche 914 still leak after fitting new seals?
Check the window adjustment, roof latches, adjoining seals and drainage paths. Correct alignment is necessary for consistent contact. - Is fitting preparation important?
Yes. Clean the retaining channels and surrounding surfaces thoroughly, and avoid stretching the rubber during installation.
Related reference numbers
Related, superseded, cross reference or alternative numbers for comparison.
914VTSS
The product you are viewing cross references to these numbers
Perfect for sealing weatherstripping to door, hood, and trunk panels.
Related reference numbers
Related, superseded, cross reference or alternative numbers for comparison.
00004330532
The product you are viewing cross references to these numbers