Please wait… 
Please wait while we process your order,
do not press the back button…
do not press the back button…
Your Vehicle
Porsche // Cayman 718C (982C) 2017>> // Cayman S 718 2.5L Manual (350 Bhp)
Enter your VAT number here and click Verify:
Your details have been verified. VAT number registered to:
,
.
Your order will now be zero rated for VAT purposes. We reserve the right to verify these details after your order request has been made and reinstate VAT if required.
Your VAT details were not recognised or were invalid. Your VAT number must be matched to your Billing Country as specified above. This is currently specified as . You do not need to enter the country code part of your VAT number as this has already been selected in your billing address details above.
The VAT number checking service is currently offline. Please supply your VAT details within the comments or special instructions field below and we will apply a VAT discount after placing your order request.
Category Filter
Race plenum and throttle body. Porsche 997 Turbo 07-09 - AP-997TT-105
AP-997TT-105
Vehicle Group
- Porsche 997 MK1 TURBO 2007-09
- Porsche 997 MKII Turbo 2010-13
Information
Race plenum and throttle body.
Fits:
Porsche 997 Turbo 2007-09
Adding bolt-on horsepower to the 997 Turbo is a continuous quest by many enthusiasts looking for more power. Reverting back to old tuning technologies, Agency Power has developed a larger throttle body and plenum kit for the Porsche 997 Turbo to gain added performance. The point of a larger throttle body is to get in more air.
The more air you bring in, the more power you make. The 997 Turbo's engine intake system works off pulses, so how that air is diverted to either side of the engine is not as important as the volume incoming. The plenum kit includes an OEM Porsche Cayenne Turbo throttle body (part# 94860511503) which is a direct bolt on and plug in for the electronic throttle control with no modifications needed.
This throttle body has a 77.64mm inner diameter compared to the stock one of 75.64mm. We chose to go with this smaller diameter throttle body to give the car more low end horsepower and torque. If the diameter of the throttle body is to big, it will increase turbo lag and performance gains will only be made at the mid to top end RPM range. Since most 997 Turbo users drive their car on the street and track, we developed this product to substantially increase throttle response and improve "usable" power.
The Agency Power plenum kit is made using high quality 6061 aluminum that has been TIG welded and pressure tested in a T shape to mimic the OEM design. The CNC machined 4 bolt throttle body flange features a groove to accompany a rubber o-ring to ensure a secure and sealed fit with the OEM Porsche Cayenne throttle body. The T plenum features the necessary fittings for stock vacuum hoses and breather lines and includes a 1 way check valve needed. Each T plenum is powder coated gloss black for an OEM look and includes new silicone couplers in black and worm clamps to secure it to the factory intake manifolds. The installation of the plenum requires removal of the factory airbox and Y pipe to access the component.
Installation of the Agency Power plenum kit DOES NOT require the ECU to be flashed. The factory ECU will adjust accordingly to the change in throttle body diameter. However, corresponding mods including an ECU flash will only bring out additional power. As it stands alone, the plenum kit will add a bolt on 20 wheel horsepower to your Porsche 997 Turbo. As tested on a VR700 kit, the plenum added nearly 45 horsepower and 60 ft/lbs of torque. Splitting and diverting the air flow and directing it towards the cylinders at a much higher air speed.
Recommended installation time is approximately 3 hours.
HP Gains: 40-45Bhp. 60 ft/lbs of torque
Related reference numbers
Related, superseded, cross reference or alternative numbers for comparison.
AP-997TT-105
The product you are viewing cross references to these numbers
Fits:
Porsche 997 Turbo 2007-09
Adding bolt-on horsepower to the 997 Turbo is a continuous quest by many enthusiasts looking for more power. Reverting back to old tuning technologies, Agency Power has developed a larger throttle body and plenum kit for the Porsche 997 Turbo to gain added performance. The point of a larger throttle body is to get in more air.
The more air you bring in, the more power you make. The 997 Turbo's engine intake system works off pulses, so how that air is diverted to either side of the engine is not as important as the volume incoming. The plenum kit includes an OEM Porsche Cayenne Turbo throttle body (part# 94860511503) which is a direct bolt on and plug in for the electronic throttle control with no modifications needed.
This throttle body has a 77.64mm inner diameter compared to the stock one of 75.64mm. We chose to go with this smaller diameter throttle body to give the car more low end horsepower and torque. If the diameter of the throttle body is to big, it will increase turbo lag and performance gains will only be made at the mid to top end RPM range. Since most 997 Turbo users drive their car on the street and track, we developed this product to substantially increase throttle response and improve "usable" power.
The Agency Power plenum kit is made using high quality 6061 aluminum that has been TIG welded and pressure tested in a T shape to mimic the OEM design. The CNC machined 4 bolt throttle body flange features a groove to accompany a rubber o-ring to ensure a secure and sealed fit with the OEM Porsche Cayenne throttle body. The T plenum features the necessary fittings for stock vacuum hoses and breather lines and includes a 1 way check valve needed. Each T plenum is powder coated gloss black for an OEM look and includes new silicone couplers in black and worm clamps to secure it to the factory intake manifolds. The installation of the plenum requires removal of the factory airbox and Y pipe to access the component.
Installation of the Agency Power plenum kit DOES NOT require the ECU to be flashed. The factory ECU will adjust accordingly to the change in throttle body diameter. However, corresponding mods including an ECU flash will only bring out additional power. As it stands alone, the plenum kit will add a bolt on 20 wheel horsepower to your Porsche 997 Turbo. As tested on a VR700 kit, the plenum added nearly 45 horsepower and 60 ft/lbs of torque. Splitting and diverting the air flow and directing it towards the cylinders at a much higher air speed.
Recommended installation time is approximately 3 hours.
HP Gains: 40-45Bhp. 60 ft/lbs of torque
Related reference numbers
Related, superseded, cross reference or alternative numbers for comparison.
AP-997TT-105
99760511500
99760511501
99760511502
The product you are viewing cross references to these numbers
Price: £1,111.71
In stock